Meat Grinder Common Faults and Repair Methods

The existence of the Meat Grinder makes it unnecessary for us to perform manual operations, and almost no use of knives or manual labor is required. After waiting for a certain period, you can use the Meat Grinder to harvest the processed minced meat, which also reduces labor costs and costs. It also guarantees the freshness and convenience of the ingredients, but after a long period of use has quality problems. We may find that the Meat Grinder is malfunctioning and cannot work normally. At this time, it is necessary to carry out certain repairs and maintenance. The following is the relevant information that everyone said.

Here is the content list:

• Repair Meat Grinder Common Faults and Repair Methods

• Daily maintenance of Meat Grinder.

Repair Meat Grinder Common Faults and Repair Methods

Fault 1: The Meat Grinder shuts down during operation.

1. The voltage is too low or the power is cut off, check whether the wiring is normal.

2. If the Meat Grinder has been used for too long, the temperature control protection function will be automatically turned on, and it will be turned on after stopping for about half an hour.

Fault 2: The phenomenon of material jamming occurs.

The blade is entangled or stuck by the material; we need to turn off the switch in time, and after disconnecting the power, take out the material, cut it into small pieces and put it into the Meat Grinder, and continue to use it with power on.

Fault 3: The Meat Grinder vibrates abnormally or makes a lot of noise.

1. It may be that the meat grinder is not securely in place. Take the material out of the Meat Grinder and place the meat grinder in place according to the instructions.

2. It may be because the Meat Grinder is placed in an unstable position. Find a relatively stable plane for the meat grinder machine to ensure its stable operation.

3. It may be because the voltage used is too high, check whether the wiring is normal.

4. Adding too much material causes the meat grinder holder to fail to operate normally. Turn off the Meat Grinder switch, turn off the power, open the cover to take out the excess material, then close the cover, and continue to use it after powering on.

Daily maintenance of Meat Grinder.

It is necessary to pay attention to waterproofing, protecting the power cord, and avoiding damage to the power cord. Every time the Meat Grinder is used, remove the meat grinder tee, screw, blade orifice, etc., clean up the residue, and install them back in order. Doing so can ensure the sanitation of the equipment and processed food, and can also ensure that the parts of the commercial meat grinder can be disassembled and assembled flexibly for easy maintenance and replacement. The blade and orifice plate of the Meat Grinder are wearing parts and may need to be replaced after a period of use.

Repairing a Meat Grinder involves knowledge of many aspects, including judgment and analysis of faults, and selection of treatment methods. These all determine whether the Meat Grinder can still work normally as before. Ordinary users, may not have a comprehensive understanding of this information. If there is a problem with the Meat Grinder, at most they will seek help from professionals, which will cost additional maintenance costs. So through the above introduction, we can understand the common sense that we should know about repairing the Meat Grinder, and then we can do it ourselves, and perhaps achieve satisfactory results.

If you are interested in electric meat grinders, you can contact us, our website is http://www.horuis.com/, welcome your arrival and look forward to cooperating with you.