Views: 0 Author: Site Editor Publish Time: 2024-09-20 Origin: Site
When the motor of the mill starts running, the connecting shaft and the grinding disc sleeve on the connecting shaft run together. The material to be ground enters the grinding sleeve from the hopper, and the relative operation between the auger of the grinding disc and the grinding sleeve causes the material to be crushed into small particles. The crushed small particles are brought into the middle of the two grinding discs under the spiral motion of the grinding disc auger. The relative operation of the grinding disc teeth causes the material to be crushed into fine powder particles in a short time. The powder flows out from the tooth groove of the grinding disc and is thrown around. At the same time, it is taken down by the powder scraper installed on the grinding disc and flows out from the powder outlet. The whole process is clean and hygienic.
1. The motor shaft of the mill is lengthened, unlike the old machine that uses another shaft sleeve on the motor shaft, which further improves the concentricity, and the machine runs more smoothly, with less vibration and less noise.
2. A silicone pad is installed between the static grinding disc and the machine wall to reduce vibration and fine-tune the grinding disc, so that the two grinding discs fit better, the grinding powder is finer, and the noise is reduced.
3. Rubber pads are installed between the motor and the motor fixing plate and under the motor fixing plate to further enhance the shock absorption and noise reduction effects.
4. The door cover and the cavity of the mill are tightly processed and matched with the step position to ensure that there is no leakage of powder, ensure the concentricity of the regulator top pad and the hexagonal sleeve of the grinding disc, reduce wear, vibration and noise.
5. The grinding cavity slope of the mill (i.e. the static grinding disc installation position) is scientifically designed to further improve the fineness of the grinding powder and achieve a taste effect that melts in the mouth.
6. The regulator groove teeth of the mill are machined to ensure the degree of processing, achieving the effect of convenient adjustment, tight matching and low noise.
7. After the grinding disc of the mill is equipped with the grinding disc and the scraper, it is tested by computer dynamic balancing to further improve the concentricity and balance, so as to minimize vibration and noise.
8. There is no bearing between the base and the motor of the mill, which is convenient for customers to disassemble and assemble, and reduces the occurrence of failures, thus improving the quality of the machine.
9. The mill achieves smooth discharge, very fine grinding, and reduced noise and vibration.
1. Free hiring of a team to answer and help you, and deal with various problems
2. Free hiring of a nutritionist to provide you with reasonable nutritional formula suggestions
3. Free hiring of an equipment engineer to deal with various problems of equipment failure The grain mill has been imitated, but never!
1. First pour the material to be ground into the hopper, start the power supply, adjust the nut that controls the coarseness, and it is better to crush the coarse (one-time crushing) and slowly discharge the material after pulling out half of the plug plate.
2. The operation method for grinding for the second time is the same as above. You only need to adjust the nut and tighten it. You can adjust it at will to achieve your ideal fineness. It can be as fine as you want.
3. If the material to be ground is dry material, people are generally worried about the large amount of dust, especially for precious medicinal materials. It is also a waste if it flies away. It is recommended that customers customize a cotton bag on the discharge port to avoid unsanitary operation and waste of materials.
